The CM6206/CM6206-LX chipset that is in many cheap USB sound card devices uses drivers by C-Media drivers from Windows 10 all the way back to Windows XP are available.
USB spec. 2.0 full speed compliant
USB audio device class spec. 1.0 and USB HID class spec. 1.1 compliant
IEC60958 spec. compliant (consumer format S/PDIF input and output with loop-back support)
SCMS (Serial Copy Management System) compliant
Dolby® digital audio streaming via S/PDIF output interface
USB remote wake-up support
6 channel DAC output with 16 bit resolution
3.1 Vpp (1.1 Vrms) biased at 2.25V output swing
Volume control and mute function
Earphone buffer
Self power / Bus power selectable (by EEPROM)
2X interpolator for digital playback data to improve quality
2 channel ADC input with 16 bit resolution
Show: Full Specs/Additional configurations
- USB spec. 2.0 full speed compliant
- USB audio device class spec. 1.0 and USB HID class spec. 1.1 compliant
- IEC60958 spec. compliant (consumer format S/PDIF input and output with loop-back support)
- SCMS (Serial Copy Management System) compliant
- Dolby® digital audio streaming via S/PDIF out
- USB remote wake-up support
- 5.1 channel DAC output with 16 bit resolution 3.1 Vpp (1.1 Vrms) biased at 2.25V output swing Volume control and mute function Earphone buffer 2X interpolator for digital playback data to improve quality
- 2 channel ADC input with 16 bit resolution 3.2 Vpp (or 4.0 Vpp programmed by vendor driver) biased at 2.25V input swing Volume control and mute function
- Additional headphone output with selectable source and phone jack sense
- Stereo MIC support with 33dB maximum capability
- Recording source select from S/PDIF, MIC, Line-in and summation of MIC, Line-in and front channel
- MIC, Line-in monitor from front channel (all channels optional) with volume control and mute function
- Master volume control by default; per-channel volume control by C-Media driver
- Playback with soft-mute function
- Support 48 / 44.1 KHz sampling rate for both playback and recording
- MCU support with two-wire serial interface
- Serial EEPROM support for customized VID/PID
- MCU / EEPROM / GPIO control via HID software interface
- Volume up / volume down / playback mute HID button
- LED indicator pins: operation / recording mute / SCMS protection
- C-Media value added software (multi-channel positional 3D sound, EQ, speaker shifter, etc.)
- Embedded USB transceiver and power on reset circuit
- Single 12MHz crystal input with embedded PLL
- Single 5V power supply with embedded 5V to 3.3V regulator
- Industry standard LQFP-48 package
- Insert the USB device into your computer/laptop.
- If Windows doesn't automatically install the device, you will need to go to the Device Manager and look for the device that will most likely have a exclamation mark next to it because the drivers were not installed.
- From here right click on the device in the device manager, and manually install the driver for the device using the driver you extracted to your computer.
